HEYLOVE. Flow base, CASUAL, 15 ml

Shade: Light Lilac

Collection: EVERYDAY

Consistency: Medium, close to thin

Hardness/Elasticity: Elastic

Acidity: Neutral, pH 6.5

Odor: Neutral

Pigmentation: Dense, covers the free edge

Application method:

1. Thoroughly degrease the nail plate using the pH Bond dehydrator.

2. Apply the acid-free Ultrabond primer to the tip of the nail and wait until the liquid is completely dry.

3. Apply a layer of clear Rubber Base as an underlayer and cure for 30 seconds.

4. Apply one or two layers of Flow Base. Cure in a UV/LED lamp for 60 seconds.

5. Apply the finishing coating (top) as the final layer.

Volume: 15 ml

Manufacturer: TM "HEYLOVE"

Country: Ukraine

Ingredients (INCI): Polyacrylic Acid, HEMA, Hydroxycyclohexyl Phenyl Ketone, Ethyl Trimethylbenzoyl Phenylphosphinate, Silica. May Contain: CI 45380, CI 15850, CI 77491, CI 15985, CI 77492, CI 77007, CI 77510, CI 77742, CI 77289, CI 77499, CI 77891, CI 77000

Warning! To avoid unwanted polymerization of the material during work, testing, or content creation, the opened bottle or brush must be kept as far away from daylight as possible, especially from direct sunlight. Please also note that even in cloudy weather, clouds allow a large amount of ultraviolet radiation to pass through, which is sufficient for the material to begin polymerizing. When painting tips, we recommend keeping the working side of the operating UV lamp facing away from the technician. If the switched-on lamp is directed toward the technician, unwanted polymerization of the material may occur on the brushes and around the necks of opened bottles.

How to prevent bubbles in the material?

Bubbles can appear in any liquid. This does not depend on the formula or ingredients. It depends on density (viscosity). It is simply a law of physics, nothing more.

For example, bubbles remain in water for a very short time and come out on their own.
If we take denser liquids (honey, thick builder gel, etc.), bubbles settle much more readily in these products and do not leave them as quickly as they do in water.

The same applies to base. If you work carelessly with the brush, sharply dipping it into the bottle, it unintentionally acts like a blender, mixing the material with air and creating bubbles. This especially applies to materials in bottles with brushes.

Therefore, use CAREFUL, gentle brush movements!
Especially when the bottle is new and full.

When we were developing the Tint Base product, we had to choose the consistency. We deliberately selected a medium consistency because it offers the following advantages:
- the material does not run or flood;
- clean contours without extra effort;
- the technician can calmly build the architecture and has enough time to check the reflection;
- there is no need to apply a second coat to refine the architecture or camouflage the free edge.

Our production facility uses equipment that prevents bubbles from forming in the material at every stage—from pigment mixing to filling the bottles.

We also warn our partners that we are against store consultants opening a bottle and showing the material to customers. This is because a consultant who is not a nail technician does not understand that they can create bubbles with the brush without even realizing it.
Not to mention that the bottle necks look unattractive when they are covered with product all the way to the top.

If bubbles have appeared in the material, how can you fix it?

Unscrew the bottle cap, but do not pull out the brush.
Leave it overnight in a warm (not hot!) place.
Or place the bottle in a plastic bag and immerse it in warm water up to the bottle shoulders.

According to the laws of physics, molecules move faster in a warm environment, which speeds up the process.
The air will rise to the surface because it is lighter than the liquid.