HEYLOVE. Frame builder Gel, SILENCE, 30 ml

FRAME gel is a universal extension gel available in 13 shades.

Packaged in a jar with a pump for dispensing the gel.

SILENCE — milky beige.

Characteristics:

• Suitable for sculpting, correction, strengthening, and file-free nail extensions;
• Medium consistency, closer to runny;
• Self-leveling;
• Elastic when applied in a thin layer, while in a thicker layer it holds the apex and does not deform;
• Creates a strong coating resistant to chipping.

Directions for use:

1. Buff the nail plate with a 180-grit file or a 100-grit buffer.

2. Remove dust with a nail cleanser, paying special attention to the cuticle area and sidewalls.

3. Apply dehydrator and wait 30 seconds for the moisture to evaporate.

4. Using rubbing motions, apply a thin priming layer of Rubber Base, then add a small amount of base to create a smooth surface. Cure for 30 seconds.

5. Press the pump to dispense the required amount of material.

6. Apply Frame Gel as an architectural layer, or place it into an upper form or a lower form, depending on the technique.

7. Cure each nail for 30 seconds, then place both hands in the lamp again for 1–2 minutes at the end.

8. Remove the sticky layer from the Frame Gel and perform surface filing if necessary.

9. Apply No Sticky Top or Dark Story Top and cure for 1–2 minutes.

Consistency: medium

Volume: 30 ml

Manufacturer: TM “HEYLOVE”

Country: Ukraine

Ingredients (INCI): Acrylates Copolymer, HEMA, Ethyl Trimethylbenzoyl Phenylphosphinate, Hydroxycyclohexyl Phenyl Ketone, Pigments.
May contain: CI 77499, CI 77891, CI 15850, CI 45380, CI 47005, CI 15510.

Warning! To prevent unwanted polymerization of the material during work, testing, or content creation, keep the open bottle or brush as far away from daylight as possible, especially from direct sunlight. Please also note that even in cloudy weather, clouds allow a large amount of ultraviolet radiation to pass through, which is sufficient for the material to begin polymerizing. When photographing nail tips, we recommend keeping the operating side of the UV lamp facing away from the nail technician. If the switched-on lamp is directed toward the nail technician, unwanted polymerization of the material may occur on the brushes and around the necks of open bottles.